Ion Exchange 10 Inch Water Filter Cartridges , Water Purifier
The resin filter cartridge is made of ion exchage resin and food
grade cartridge housing .
It removes calcium and magnesium ions from water by exchanging them
with harmless sodium ion .
Fiter media : Ion Exchange resin
Filter rate : 5um/10um
Length : 10 "
Gasket : Silion,EPDM , NBR
Outer/Inner diameter : 2.5" 4.5"/28 mm
Max operating temperature : 52C
Max operating pressure : 2.4 Bar
Folding resin filter
Resin is a porous , insoluble exchange material . Soft water
machine in the resin filter contains millions of tiny resin ball
(beads) , all the small ball contains many positive ions to absorb
negative charge exchange position . When the resin is in a nascent
state , these charge exchange sites are occupied by positively
charged sodium ions . As the calcium and magnesium pass through the
resin reservoir , they contact the resin beads , displacing the
sodium ions from the exchange site . The resin preferentially binds
strongly charged cations , and the calcium and magnesium ions are
more strongly charged than sodium ions . Instead of sodium cations
, and then down through the resin "bed , out of the soft water
machine , so the soft water machine to send out . Finally , all the
resin exchange positions are occupied by calcium and magnesium ,
and then can not work .
1 . After installing this new cartridge , pass 5 gallons of tap
water through to flush out any resin fine particle present in the
2 . Air bubbles may be present for the first few days after
3 . To keep your filter system operating efficiently , replace this
cartridge annually or by the recommendation of your experienced
water conditions dealer .
First time using
Water purifier for the first time should be strictly in accordance
with the following steps before washing , otherwise it will affect
the water purification machine performance and pre-water quality .
The first time before the use of water washing machine should be
washed away to protect the water inside the machine , as follows :
1 . the tap , tap water inlet valve , clean tap all open , rinse
for 15 minutes until the production of water without bubbles so far
. Flushing the process of frequent switching tap (off 3 seconds ,
open 10 seconds) so that the formation of pulsating water flow
impact , will make better washing effect .
2 . close the sewage faucet , open the faucet , water system can be
used normally after 5 minutes .